ALL PHYSICS DOUBTS - POST HERE !!

[thenewkid™]

another1 m/j 08 p6 q 1b
Thanks


i love freekicks

[Vin]

sure nytime .. luv ur trade mark ..

[Vin]

another1 m/j 08 p6 q 1b
Thanks


i love freekicks

ya i've solved this one .. gimme some time gotta hav my lunch .. i''l be bak in a tick ..

[thenewkid™]

here:)

I wanted may june 2008 quest 2 b (i)

[Ghost Of Highbury]

another1 m/j 08 p6 q 1b
Thanks


i love freekicks

Stick/Attach a pin to the 10.cm mark. place the center of the cylinder exactly on the pin. remove the pin

[Fastal]

here:)

oops i did the wrong question(4b)

2b(i)
yes you can write that the numbers are close enough, only 0.03 ohm difference between doubled resistance of circuit 1 and circuit 2.

2(b)(ii)
-repeats
-switch circuit off between readings.

1(b)
Find center using 2 blocks on the sideslike this --->
|()|
then extend it so that the diameter is seen, put half of the cylinder to make sure the marks match and than push it farther in.(you can draw a diagram for all of this)
 

[thenewkid™]

Can please tell me the justification for 2 b (i)


Ilv 2 take freekicks

[Fastal]

Can please tell me the justification for 2 b (i)


Ilv 2 take freekicks

values are close enough, only 0.03 ohm difference between doubled resistance of circuit 1 and circuit 2.

[thenewkid™]

Thanks  4 ans my questions

mj 2006 p6 q 1d

[The Golden Girl =D]

umm By the way do we have to kno what a micrometer screw guage means? ....cuz i saw it mentioned in jun 2003 paper 6 .....
in other words , it is included in the syllabus ?

[Fastal]

Thanks  4 ans my questions

mj 2006 p6 q 1d

5.8*6*0.2=6.96 cm³

[Vin]

Stick/Attach a pin to the 10.cm mark. place the center of the cylinder exactly on the pin. remove the pin

can we use a marker pen ?? to mark the centre of the cylinder (using a scale) ..

[thenewkid™]

Thanks fastal

[Ghost Of Highbury]

1d) the volume of air = length of card * width of card * 2.5mm (2-3)

     vol = 6 * 5.8 * 0.25 = 8.7cm^3

@golden girl - yes its very important

@Vin- Yes u can, with a pin, u find the 10cm mark. mark the center of the cylinder and put it on the pin.

[The Golden Girl =D]

umm By the way do we have to kno what a micrometer screw guage means? ....cuz i saw it mentioned in jun 2003 paper 6 .....
in other words , it is included in the syllabus ?

!!!!!!!!!!!!!!!!!!!!!!!!!!!?!?!!?!?!?!??!