« previous next »
Pages: [1]   Go Down

Author Topic: Physics paper 6 urgent help!!  (Read 1229 times)

Offline rahuldevnani93

  • Newbie
  • *
  • Posts: 48
  • Reputation: 62
Physics paper 6 urgent help!!
« on: May 10, 2010, 08:46:50 am »
May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.

May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?

Please reply as soon as possible
Logged

Offline rahuldevnani93

  • Newbie
  • *
  • Posts: 48
  • Reputation: 62
Re: Physics paper 6 urgent help!!
« Reply #1 on: May 10, 2010, 08:57:33 am »
May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.

May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?

Please reply as soon as possible

http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s04_qp_6.pdf
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s08_qp_6.pdf
Logged

Offline Priceless

  • SF Master
  • ******
  • Posts: 2071
  • Reputation: 1591
Re: Physics paper 6 urgent help!!
« Reply #2 on: May 10, 2010, 12:07:07 pm »
Quote from: rahuldevnani93 on May 10, 2010, 08:57:33 am
May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.

May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?

Please reply as soon as possible

http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s04_qp_6.pdf
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s08_qp_6.pdf
hey....i did ig physics last yr n m not taking phy atm.....i no da answers but im not 100% sure....i wud advise you 2 just use da mark scheme in such questions :)

dw dat much about phy p6.....all da best :)   
Logged
Don't say "God I have tooo many problems" but say "Problems I have God!"   Gud Luck 2 all 4 xams. Hope v all du well.....fingers crossed LOL

Offline Adzel

  • SF Citizen
  • ***
  • Posts: 230
  • Reputation: 272
  • ALLAH IS THE GREATEST
Re: Physics paper 6 urgent help!!
« Reply #3 on: May 10, 2010, 12:47:32 pm »
May/June 2004 - ANS Q1 b) - Remove the electrodes from beaker.
                                      - Make the electrodes fixed so they cannot move.
                                      - Measure the lengthbetween them, and return them slowly inside the beaker.
                                               

                                  c) Temperature                                 
                                   
May/June 2004 - ANS Q3 c) ii) The question says "Complete Fig. 3.1 by drawing in the voltmeter and the ammeter, using conventional
                                          symbols." So no variable resistor is required (see Attached)


May/June 2008 - ANS Q1 b) (see atached) - Place pin above 10.0 mark on rule, put cylinder ontop of the pin and remove the pin slowly.

May/June 2008 - ANS Q2 - Statement is yes, How to justify - circuit 1 resistors are connected in parallel, while circuit 2 two are conncted in series.
Logged

Offline rahuldevnani93

  • Newbie
  • *
  • Posts: 48
  • Reputation: 62
Re: Physics paper 6 urgent help!!
« Reply #4 on: May 10, 2010, 03:27:08 pm »
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s09_qp_6.pdf

Guys this paper is May/ June 2009 and the question 5 b) is hitting my head.
The answer in the markscheme is :-
  • Readings taken at either side/diameter of cylinder
  • Position of mid point found
  • Mark position of centre

Please give me this answer in a diagram if possible !
thank you
Logged

Offline Fastal

  • SF Citizen
  • ***
  • Posts: 181
  • Reputation: 341
Re: Physics paper 6 urgent help!!
« Reply #5 on: May 10, 2010, 04:57:47 pm »
Quote from: rahuldevnani93 on May 10, 2010, 03:27:08 pm
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s09_qp_6.pdf

Guys this paper is May/ June 2009 and the question 5 b) is hitting my head.
The answer in the markscheme is :-
  • Readings taken at either side/diameter of cylinder
  • Position of mid point found
  • Mark position of centre

Please give me this answer in a diagram if possible !
thank you
Logged
Pages: [1]   Go Up
« previous next »