Qualification > Sciences
Physics paper 6 urgent help!!
rahuldevnani93:
May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.
May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?
Please reply as soon as possible
rahuldevnani93:
May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.
May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?
Please reply as soon as possible
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s04_qp_6.pdf
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s08_qp_6.pdf
Priceless:
--- Quote from: rahuldevnani93 on May 10, 2010, 08:57:33 am ---May/June 2004 - Q1 b) and c)
May/June 2004 - Q3 c) ii) Should we put a different variable resistor for each lamp in parallel or only one in the beginning.
May/June 2008 - Q1 b)
May/June 2008 - Q2 - Statement is yes, How to justify?
Please reply as soon as possible
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s04_qp_6.pdf
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s08_qp_6.pdf
--- End quote ---
hey....i did ig physics last yr n m not taking phy atm.....i no da answers but im not 100% sure....i wud advise you 2 just use da mark scheme in such questions :)
dw dat much about phy p6.....all da best :)
Adzel:
May/June 2004 - ANS Q1 b) - Remove the electrodes from beaker.
- Make the electrodes fixed so they cannot move.
- Measure the lengthbetween them, and return them slowly inside the beaker.
c) Temperature
May/June 2004 - ANS Q3 c) ii) The question says "Complete Fig. 3.1 by drawing in the voltmeter and the ammeter, using conventional
symbols." So no variable resistor is required (see Attached)
May/June 2008 - ANS Q1 b) (see atached) - Place pin above 10.0 mark on rule, put cylinder ontop of the pin and remove the pin slowly.
May/June 2008 - ANS Q2 - Statement is yes, How to justify - circuit 1 resistors are connected in parallel, while circuit 2 two are conncted in series.
rahuldevnani93:
http://www.xtremepapers.net/CIE/Cambridge%20IGCSE/0625%20-%20Physics/0625_s09_qp_6.pdf
Guys this paper is May/ June 2009 and the question 5 b) is hitting my head.
The answer in the markscheme is :-
* Readings taken at either side/diameter of cylinder
* Position of mid point found
* Mark position of centre
Please give me this answer in a diagram if possible !
thank you
Navigation
[0] Message Index
[#] Next page
Go to full version